SHUTTLE-ECHO - MANUAL


The MONO-mode does NOT distort the original stereo-image. Each channel has it's own delay-chain, in mono-mode they both use the same settings.


TIME: delay time
FEEDBACK: amount of repeats
250 ms/750 ms: maximum delay time


-TIME MOD-

This feature modulates the delay time. The slider activates the effect & sets how much the delay time is affected.

SINE/S&H: Selects between a sinewave or sample & hold LFO. (sample & hold changes to a random delaytime value at the rate of the speed control)


-FLUTTER-

Pitch modulation effect (applied to the repeats only). The slider activates the effect & sets the mix.

SINE/S&H: Selects between a sinewave or sample & hold waveform. (sample & hold creates random pitch changes at the rate of the speed control)


-FILTER-

The slider activates & controls the mix of the filter.

FREQ: Cutoff frequency
RES: Resonance
HIGHPASS/LOWPASS: Filter-mode

-DRIVE-

Overdrive (applied to the repeats only). The slider activates & controls the dry/wet mix.

DRIVE: amount of drive (waveshape)
TRHESH: Threshold. This sets the level where the waveshaping occurs (increases volume with high drive settings).
PRE FILTER/POST FILTER: puts the drive-section before or after the filter.

MIX: Dry/wet mix



This plugin was developed by Stephen Daveloose
(using SynthEdit, created by Jeff McClintock, softdrive v2.230 by scoofster & U-MathEV v0.3 by Unkargherth)
version 1.1: 07 2008
GUI by Stephen Daveloose


(c) shuttleplugs

www.shuttlebugrecords.com


